Chain Lubrication; Operating The Chainsaw; Switching On - FLORABEST FKS 2200 F3 Traduction Des Instructions D'origine

To loosen the tension, turn the
chain adjustment ring anti-
clockwise.
4. Tighten up the fastening bolt (14)
again (
With a new saw chain, you must
readjust the chain tension after at
least 5 cutting operations.

Chain lubrication

The rail and chain must never be
without oil. If you operate the elec-
tric chainsaw with too little oil, the
cutting performance and the lifetime
of the saw chain is reduced, since
the chain becomes blunt faster. You
can identify a case of too little oil
where smoke development or dis-
coloration of the rail occurs.
As soon as the motor is speeded up, the oil
also flows faster to the chain bar (4).
Filling up with chain oil:
• Check the oil level indicator (
regularly and top-up the oil if the mini-
mum mark „MIN" (
the oil level indicator. The oil tank holds
about 190 ml of oil.
• Use Parkside bio-oil; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center.
• If you have no Grizzly bio-oil available,
use chain lubrication oil with low adhe-
sive additive content.
• Empty the oil tank before longer periods
(6-8 weeks) of non-use.
C
1. Unscrew the oil fill cap (2) and fill
up with chain oil.
All manuals and user guides at all-guides.com
).
21)
C
22) is reached on
C
2. Wipe off any spilled oil and
close the cap (2) again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.

Operating the chainsaw

Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled. Ensure the voltage of the
mains connection agrees with the
label on the device. Make sure you
have a secure stance. Make sure
before you start that the electric
chain saw is not touching anything.
Caution! Saw can oil up, see notes
on "Assembly".

Switching on

1. Check before the start, whether
D
sufficient chain oil is in the tank
and, if necessary, refill with
chain oil (see Chapter Operation
Startup).
2. Form a loop from the end of the
extension cable and hang this
into the tension relief (17) on the
rear grip (1).
3. Connect the device to the mains
voltage.
4. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (8).
5. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear grip (1) and
the left hand on the front handle
GB
6 9