Fixing/Attaching The Shoulder Strap; Mounting The Saw Chain And Blade; Tightening And Checking The Saw Chain; Lubricating The Chain - FLORABEST FAHE 20-Li A1 Traduction Des Instructions D'origine

Fixing/attaching the shoulder strap

♦ Hook the shoulder strap
lug .
♦ Adjust the length of the shoulder strap
your size so that carrying lug
when hooked in place.
♦ In addition, you can adjust the height of the
carrying lug on the appliance shaft
loosening the screw.

Mounting the saw chain and blade

WARNING!
► Wear protective gloves! There is a danger
of injury from the sharp cutting teeth!
► The sprocket cover
tensioning ring
are not pre-assembled on the appliance at
delivery.
► The turning of the blade
the manufacturer.
► The chain travel direction
must be adhered to every assembly.
♦ Place the saw chain
Ensure that the saw chain
the correct direction.
♦ Attach the blade
upwards and guide the saw chain
the chain sprocket
The guide rail must be above the blade
guide .
♦ Put the sprocket cover
♦ Tighten the fixing screw
♦ Now, tighten the saw chain

Tightening and checking the saw chain).

♦ Tighten the fixing screw
Tightening and checking the saw
chain
WARNING!
► Wear protective gloves! There is a danger of
injury from the sharp cutting teeth!
♦ Undo the fixing screw
♦ Turn the chain tensioning ring
direction to increase the tension.
■ 30 │ GB │ IE
into the carrying
to
is at hip height
by
together with the chain
and the fixing screw
is not intended by
on the blade
in the blade groove.
is running in
with the labelling facing
around
.
on.
slightly.
(see section
completely.
.
in a clockwise
♦ The saw chain must lie against the underside
of the blade.
Check whether the saw chain
over the blade by hand
♦ Now tighten the fixing screw
NOTE
► A new saw chain
tightened more regularly.

Lubricating the chain

♦ Remove the oil filler cap
♦ Fill the oil tank with approx. 65 ml of organic
chain oil .
WARNING!
► Never work without chain lubrication!
If the saw chain
equipment may become irreparably dam-
aged within a short time. Always check chain
lubrication and oil level
starting work.
NOTE
► Use only saw chain oil. Preferably biodegrad-
able. Do not use waste oil, motor oil, etc.
► While working, check whether the automatic
chain lubrication is working correctly. Check
the chain lubricator before and during work.

Sharpening the saw chain

NOTE
► You will find detailed information on
sharpening in the sharpening set, e.g. from
Oregon.
► Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
► If you have any doubts about implementing the
work, the saw chain
can be drawn
.
completely.
stretches and must be
.
runs dry, the cutting
in the tank before
should be replaced.
FAHE 20-Li A1