Safety Functions; Assembly; Mount The Saw Chain - FLORABEST FKS 2200 F3 Traduction Des Instructions D'origine

Damaged protective devices and parts
have to be repared or changed except
as noted otherwise in this manual.

Safety functions

1 Rear grip
A
with hand guard (16)
Protects the hand against branch-
es and boughs in the case of
springing away by the chain.
3 Chain braking lever/
hand guard
Control system, which stops the
saw chain immediately in case
of a spring-back; lever can also
be activated manually; protects
the left hand of the operator if it
slides from the front grip.
The motor cannot be turned on if
the chain brake has engaged.
5 Saw chain with small
spring-back
Helps you to catch spring-backs
with specially developed control
systems.
7 Metal stop claw
Reinforces the stability when
vertical cuts are carried out and
facilitates sawing.
9 Electric motor
Double insulated for safety
reasons.
10 On-off switch with safety
chain brake
On releasing the On/Off switch,
the device immediately switches off.
11 Switch-on block
The switch-on block must be
released for switching on the
device.
All manuals and user guides at all-guides.com
12 Chain catcher
Decreases the danger of injuries
the chain breaks or if it comes off.

Assembly

Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself -– injury hazard!
Before putting the electric chain saw into
operation, you must:
- install the blade, saw chain and chain
cover where necessary,
- adjust the saw chain tension,
- pour in chain oil,
- check the function of the chain brake
and the automatic oil pump.

Mount the saw chain

1. Spread the chain (5) out into a
G
loop with the cutting edges run-
ning clockwise .
2. Relax the tensioning screw (24)
against the clockwise
direction.
3. Slide the saw chain (5) into the
bar guide groove. To mount the
guide bar (4), raise it to an angle
of approx. 45 degrees. This will
make it easier to replace the saw
chain (5) onto the sprocket (25).
It is normal that the saw chain (5)
is slack. Sagging in the chain is
normal.
4. Pre-tighten the chain (5) by turn-
ing the tensioning plate (24)
clockwise.
GB
if
6 7