Mitsubishi Electric a Serie Manuel page 85

α
2 Simple Application Controllers
13.1 Introduction
The AL2-2TC-ADP should be used convert thermocouple sensor (K type) temperature input to
0-10V voltage analog signal for use in the main unit.
13.1.1 External Dimensions
Figure 13.1:External Dimensions
1 2 3
7
4
5
35.5(1.40")
13.2 System Configuration
Figure 13.2:
Power Supply
24V DC
AL2-14MR-D
AL2-24MR-D
For general specifications please refer to Chapter 2.
Table 13.2: Applicable Version
PLC Type
α
2 Series (DC Version only)
VLS Software
Note
The AL2-2TC-ADP cannot be used with the original
Unit:mm (inches)
8
1.5(0.06") 31.0(1.23")
6 5
DC power line
Analog signal
AL2-2TC-ADP
K-type
Thermocouple
Table 13.1:
Item
1 +24V DC Power Supply
2 Channel 1 Voltage Output Terminal
3 Channel 2 Voltage Output Terminal
Channel 1 K-Type Thermocouple
4
Sensor Input Terminal
5 Shield Grounding Terminal
Channel 2 K-Type Thermocouple
6
Sensor Input Terminal
7 Jumper pins for adjustment
8 Power LED
AL2-2TC-ADP AL2-2TC-ADP
K-type
Thermocouple
Applicable version
V2.00 or later
V2.30 or later
α
Series Controllers.
AL2-2TC-ADP 13
Description
K-type
Thermocouple
ENG-73
ENG