Typographical Conventions; Safety Rules - Avigilon ES-HD-HWS Manuel D'instructions

1 About this manual
Before installing and using this unit, please read
this manual carefully. Be sure to keep it handy for
later reference.

1.1 Typographical conventions

DANGER!
High level hazard.
Risk of electric shock. Disconnect the
power supply before proceeding with any
operation, unless indicated otherwise.
WARNING!
Medium level hazard.
This operation is very important for the
system to function properly. Please read
the procedure described very carefully and
carry it out as instructed.
INFO
Description of system specifications.
We recommend reading this part carefully
in order to understand the subsequent
stages.
2 Notes on copyright and
information on trademarks
The quoted names of products or companies are
trademarks or registered trademarks.
ES-HD-HWS/ES-HD-CWS/ES-HD-HWS-LG/ES-HD-CWS-LG

3 Safety rules

The manufacturer declines all
responsibility for any damage caused
by an improper use of the appliances
mentioned in this manual. Furthermore,
the manufacturer reserves the right to
modify its contents without any prior
notice. The documentation contained
in this manual has been collected with
great care, the manufacturer, however,
cannot take any liability for its use. The
same thing can be said for any person
or company involved in the creation and
production of this manual.
• The device must be installed only and
exclusively by qualified technical personnel.
• Before starting any operation, make sure the
power supply is disconnected.
• Do not use power supply cables that seem worn
or old.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook. Improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
• Use only original spare parts. Non-original spare
parts could cause fire, electrical discharge or
other hazards.
• Before proceeding with installation check the
supplied material to make sure it corresponds
to the order specification by examining the
identification labels (4.2 Product markings, page
4).
• This device was designed to be permanently
installed on a building or on a suitable structure.
The device must be installed permanently
before any operation.
• When installing the device, comply with all the
national standards.
3