Throttle Control - Polini Motori THOR 202 Instructions Pour L'utilisation Et L'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

21- THROTTLE CONTROL

Fix it to the carburetor by using the proper support (not supplied). After
assembling the throttle control, check that its travel is enough to reach
the carburetor valve opening and check that recovery is good in order
to avoid the engine staying accelerated. Connect the electrical wires of
the throttle, one on the mass wire of the coil and the other on the + of
the coil (female connector)
22- PROPELLER
The propeller is a key component to ensure the proper engine opera-
tion. For this reason it is a must to use Polini Motori propellers only.
The use of a no-proper propeller may compromise the engine working
and make the guarantee null.
Instructions to fix the propeller flange
!
CAUTION: tight the propeller flange following carefully the se-
quence below
-Place the washer on the gear shaft
-Place the flange matching it to the rows of the gear shaft with the
projecting side toward the engine
-Place the centering nut with left threat and hand-screw it till the end on
the flange. (the nut will be tightened at all at a later stage)
-Place the propeller, the plate and the 6 M8 screws, hand-screw the 6
crews without tightening them at all but leaving them unscrewed just a
little bit. (about one turn less before the first beat.
-Tighten the centering nut at 80Nm counter clockwise.
-Finish the mounting by tightening the propeller screws crosswise fol
lowing the propeller manufacturer's instructions about the Nm to apply
to the tightening.
!
CAUTION! Before each flight always check that the propeller
screws and centering nut are firmly tightened.
17
17
ENGLISH

Publicité

Table des Matières
loading

Table des Matières