Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16
!
ATTENTION: to install different batteries may cause serious
injuries or death.
11.2 FUEL SYSTEM
Prearrange the frame with a proper tank and its pump to let the fuel
reach the carburetor. Connect the fuel pipe to the manifold on the car-
buretor, fix it using a clamp and verify that there is not air coming in.
11.3 THROTTLE CONTROL
Fix it to the carburetor by using the proper support (not supplied).
After assembling the throttle control, check that its travel is enough
to reach the carburetor throttle valve opening and check that, at the
moment of the release, it closes completely, without hitches, in order
to avoid the engine staying accelerated. Connect the electrical wires of
the throttle, one on the mass wire of the coil and the other on the + of
the coil (female connector).
11.4 PROPELLER
The propeller is an essential component for the proper engine opera-
tion. For this reason it is a must to use Polini Motori propellers only.
The use of a not proper propeller may compromise the engine working
and make the guarantee null.
Instructions to fix the propeller flange
!
CAUTION: tight the propeller flange following carefully the
sequence below
- Place the washer on the gear shaft
- Place the flange matching it to the rows of the gear shaft with the
protruding side toward the engine
- Place the centering nut and hand-screw it till the end on the flange.
(the nut will be tightened at all at a later stage)
- Place the propeller, the plate and the 6 M8 screws, hand-screw the 6
crews without tightening them at all but leaving them unscrewed just a
little bit. (about one turn less before the first beat.
- Tighten the centering nut at 80Nm
- Finish the mounting by tightening the propeller screws crosswise
following the propeller manufacturer's instructions about the Nm to
apply to the tightening.
!
CAUTION! Before each flight always check that the propeller
screws and centering nut are firmly tightened.
11.5 CONNECTION OF THE VOLTAGE REGULATOR (OPTIO-
NAL)
Connect the voltage regulator to the connector. Connect the red cable
to the positive pole of a lead battery (photo 10 and 11).
ENGLISH
!
ATTENTION: the engine is equipped with lead acid battery.
It is absolutely forbidden to use battery that are not standard lead-acid
ones as indicated in the assembly instruction of the tension regulator.
!
ATTENTION: to install different batteries may cause serious
injuries or death.
VECCHIO REGOLATORE DI TENSIONE
BIANCO
BLU - BLUE - BLEU
NUOVO REGOLATORE DI TENSIONE
10
11
ROSSO - RED - ROUGE
(E)
11
ROSSO - RED - ROUGE (E)
BIANCO - WHITE - BLANC
BLU - BLUE - BLEU
Publicité
Table des Matières
