Charging Rechargeable Batteries; Changing Channels - Topcom TWINTALKER 1302 Manuel D'utilisateur

Masquer les pouces Voir aussi pour TWINTALKER 1302:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
13

CHARGING RECHARGEABLE BATTERIES

The PMR can be used with 3 rechargeable NiMh AAA batteries.
Only use the AC/DC ADAPTER with "AAA" rechargeable batteries. Do not try to charge
this unit when regular "AAA" alkaline batteries are installed.
When using rechargeable batteries you can use the optional adapter to charge.
• Insert 3 "AAA" rechargeable batteries .
• Plug the small plug of the 7,5 V DC / 200 mA adapter into the SPK/MIC/CHG jack and the
other end in the electrical socket.
• Make sure that the unit is switched off in order to charge the batteries properly. There is no
charge indicator during charging at OFF mode.
NOTE: It takes approximately 7 to 10 hours to fully charge the batteries.
14
USING THE TWINTALKER 1302
14.1 TURNING THE UNIT ON/OFF
To activate; press and hold
To switch off; press and hold
14.2 ADJUSTING SPEAKER VOLUME
The Speaker Volume can be adjusted using
SC
LCD.
TX RX
14.3 RECEIVING A SIGNAL
The unit is continuously in the RECEIVE mode when the unit is ON and not transmitting. When you
receive a signal on the current channel, the RX icon is displayed.
SC
TX
RX
14.4 TRANSMITTING A SIGNAL
• Press and hold
SC
• Hold the unit in a vertical position with the MICROPHONE 10 cm from the mouth and speak into the
microphone.
• Release
TX
RX

14.5 CHANGING CHANNELS

The PMR has 8 available channels.
To change channels:
• Press
• Press
SC
• Press
PTT
TX RX
NOTE: Any PMR set on the same channel can receive and listen to the conversation.
TOPCOM TWINTALKER 1302 DUO COMBI PACK
. The unit will "beep" and the LCD Screen will display the current channel.
again. The unit will "beep" and the LCD Screen will turn blank.
In order for other people to receive your transmission, they must be set
on the same channel.
to TRANSMIT.
PTT
when you have finished transmitting.
PTT
once, the current channel number flashes on the LCD Screen.
or
to change the channel.
to confirm the channel selection and return to NORMAL mode.
TOPCOM TWINTALKER 1302 DUO COMBI PACK
/
. The Speaker Volume level is displayed on the
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rc-6400

Table des Matières