General Lubrication - Ariens Sno-Tek 24E Manuel Du Propriétaire

GENERAL LUBRICATION

(Figure 18)
IMPORTANT: Wipe each fitting clean before
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to
get on friction disc, friction plate or belts.
NOTE: Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS on page 32.
All manuals and user guides at all-guides.com
The unit should be lubricated (Figure 18) at
beginning of season or every 25 operating
hours.
Auger Shaft
NOTE: To grease auger shaft, remove shear
bolt nuts, and shear bolts. Apply grease at the
grease zerks and then turn the auger
assemblies on the auger shaft. Replace
shear bolts per instructions in Shear Bolts on
page 24.
2x
Figure 18
GB - 23
Grease
Oil
2x