Wiring Diagram - Faber MAGNUM Instructions D'installation

WIRING DIAGRAM

USE AND CARE INFORMATION
This rangehood system is designed to remove smoke,
cooking vapors and odors from the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from
the kitchen.
Rangehood Control Panel
The control panel is located on the right-hand side under the
canopy. The position and function of each control button
are indicated in FIGURE 13.
NOTE: It is not recommended to use the lighting as
a night light or for an extended time beyond normal
cooking times. The halogen lights life span will be
reduced.
0 1 0
L
FIGURE 13
1 0 1 2
M V
Light On/Off Button ( L )
On/Off switch for the halogen lights. Move the switch to
"1" to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower.
turn the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Speed control for blower. Move the switch to position
1 for LOW Speed, 2 for MEDIUM speed and 3 for HIGH
speed.
For Best Results
Start the rangehood several minutes before cooking to
develop proper airflow. Allow the unit to operate for several
minutes after cooking is complete to clear all smoke and
odors from the kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently
in hot detergent solution or washed in the dishwasher. Clean
exterior surfaces with a commercially available stainless
steel cleaner. Abrasives and scouring agents can scratch
stainless steel finishes and should not be used to clean
finished surfaces.
Replacing the Halogen Lamps
Purchase halogen bulb - (Max 20W, 12V, type MR11 bulb
with glass lens)
Before you begin, make sure that the rangehood is turned off and
that the other lamps have had sufficient time to cool. Halogen
bulbs burn extremely hot and serious injury could result from
touching a hot bulb. To replace the lamp, the bezel (A) around the
lamp(C) must be removed as indicated in FIGURE 14. This bezel
(A) is held in place by two screws (B). Remove the two screws and
the bezel. Then remove the lamp and replace with a new lamp.
Once the new lamp is in place, reinstall the bezel.
An alternative method to replace the lamps is to use a 1
1/4" suction cup (FIGURE 15). Attach the suction cup to
the bulb and pull firmly down on the bulb and replace with
a new lamp
FIGURE 14
FIGURE 15
Move the switch to "1" to
Version 09/12 - Page 7