Wiring Diagram - Faber Tratto Isola Instructions D'installation

WIRING DIAGRAM

Y-G
Y-G
BLU
RED
WHT
BLU
BLK
ORG
Y-G
BLK WHT
BLK RED
ORG
ORG
RED
VLT
ORG
ORG
RED
VLT
• This rangehood uses 20 watt, G4 Bi - Pin halogen lamps.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from the
kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently in
hot detergent solution or washed in the dishwasher. Stainless
steel cleaner should be used on stainless rangehoods. Abrasives
and scouring agents can scratch stainless steel finishes and should
not be used to clean finished surfaces.
Replacing the Lamps
Remove the snap-on lamp cover (as indicated in FIGURE 19) by
levering it from under the metal ring, supporting it with one hand.
Remove the halogen lamp from the lamp holder by pulling gently.
Replace the lamp with a new one of the same type, making
sure that you insert the two pins properly into the housings on
the lamp holder. Replace the snap-on lamp cover.
CN12
BLK BLK
WHT WHT
BRW BRW
GRY GRY
BLU BLU
RED RED
PNK PNK
VLT(ORG) VLT(ORG)
RED(ORG) RED(ORG)
RED RED
VLT VLT
FIGURE 19
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel is located on the front edge of the rangehood
canopy. The position and function of each control button are
indicated in FIGURE 18.
A
CN9
Button A. Press button to turn fan on / off. Current speed is
displayed in C display (1, 2, 3)
Button B. Press to reduce fan speed to as low as speed
1, display C shows the speed selected (1, 2, 3). Hold for 3
VLT
RED seconds to turn on 30 minute delay feature which runs the
hood for 30 minutes and automatically shuts the hood off.
Current speed on 30 minute delay is shown in C display with
a blinking light to indicate 30 minute mode. Shut off the 30
minute mode by holding down the button for 3 seconds
Button C. LED single digit readout display screen
Button D. Press button to increase fan speed up to speed 3.
Hold for 3 seconds to activate intensive speed mode which
operates hood on highest speed for 10 minutes and then
returns to previous speed setting. Display C indicates intensive
speed with an "H" and blinking light. Shut off the intensive
speed mode by holding down the button for 3 seconds
Button E. Press the button to turn on and off lighting. Press
once to turn the dimmer light on, press twice to turn the normal
light setting on, and press again to turn off the lighting.
USE AND CARE INFORMATION
B C
Version 02/12 - Page 10
FIGURE 18
D E