Install The Smart Led Light - Chamberlain RJO70 Instructions D'installation

Installation
(continued)
IMPORTANT INSTALLATION INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
• This portable luminaire has a polarized plug (one
blade is wider than the other) as a feature to reduce
the risk of electric shock.
• This plug will fit in a polarized outlet ONLY one way.
If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician.
9
Install the Smart LED
Light
The Smart LED Light is designed to plug
directly into a standard 120V outlet.
Select an appropriate location on the
ceiling or wall to mount the light within
6 feet (1.83 m) of an electrical outlet so
that the cord and light are away from
moving parts.
NOTE: If installing light on drywall and
a ceiling joist cannot be located, use
drywall anchors provided. No pilot hole
is required for drywall anchors.
1. Drill pilot holes 6-1/8" (15.6 cm)
apart if mounting to joist.
OR
Screw in drywall anchors 6-1/8"
(15.6 cm) apart if mounting to
drywall.
2. Determine the length of power cord
needed to reach the nearest outlet.
Wind any excess cord around cord
retainer on the top side of the light
base. Route the cord through the
channel so the light mounts flush.
3. Open the light lens.
4. Mount the light with the screws
provided.
5. Close the light lens.
6. Plug in the light to the outlet.
NOTE: The LED light is very bright. DO
NOT stare at the light while on a ladder.
Your remote light has already been
programmed at the factory to operate
with your garage door opener. Any
additional or replacement remote lights
will need to be programmed.
•. DO NOT alter the plug.
•. Light is intended for ceiling or wall mount and
indoor applications ONLY.
HARDWARE
Drywall Anchor (screw-in) (2)
Cord Retainer
Channel
Light Lens
17
Screw #6x1" (2)
6-1/8" (15.6 cm)
Drywall
Anchors
Screws