Transport; Storing The Automatic Lawn Mower - AL-KO solo Robolinho 1100 Traduction De La Notice D'utilisation Originale

Transport

IMPORTANT!
Damage to the appliance due to incor-
rect repair
The blade plate can be damaged by the
alignment of a bent, built-in cutting blade.
■
Do not align bent cutting blades.
■
Replace bent cutting blades by ori-
ginal spare parts from AL-KO.
CAUTION!
Danger of injury due to the cutting
blade
The cutting blades are very sharp and
can cause cutting injuries.
■
Wear protective gloves.
■
Make sure that parts of the body do
not get into the cutting blade.
1. Switching off the appliance.
2. Put down the appliance with the cutting
blades pointing upwards.
3. Unscrew the fastening screws with a span-
ner.
4. Pull the cutting blade out of the blade seat.
5. Clean the blade seat with a soft brush.
6. Push in a new cutting blade.
Note: It is only allowed to use original spare
parts from AL-KO.
7. Insert the fastening screws again and firmly
tighten.
As a rule, the clearer blades do not need to be
replaced.
In case of stubborn dirt that cannot be removed
with a brush, the blade plate must be replaced
because an imbalance can lead to increased
noise levels, greater wear and malfunctions.
9.4 Replacing the fuse on the
transformer (11)
If the transformer no longer provides any current
although the mains voltage supply is intact:
1. Disconnect the transformer (11/2) from the
mains supply.
2. Unscrew the fuse cover (11/1) including the
fuse from the transformer (11/2).
3. Check the fuse. If defective, insert a new fuse
with the same rating (2.5 A, slow blow).
4. Insert the new fuse in the fuse cover.
5. Screw in the fuse cover including the fuse
into the transformer.
457290_a
10 TRANSPORT
For transporting the appliance, e.g. from the main
area to the secondary area, proceed as follows:
1. Stopping the appliance.
2. Switching off the appliance.
3. Lift the appliance by the carrier bar:
■
Do not touch the cutting blades.
■
The cutting blades must always point
away from the body.
11 STORAGE

11.1 Storing the automatic lawn mower

The appliance must be stored over winter or
when it is to be taken out of service for an expec-
ted duration of longer than 30 days.
1. Fully charge the rechargeable battery (see
chapter 5.1 "Charging the rechargeable bat-
tery (09)", page 46).
2. Thoroughly clean the appliance (see chapter
9.1 "Cleaning", page 50).
3. Store the appliance:
■
upright on all wheels
■
at a dry, lockable location protected from
frost
■
out of the reach of children
11.2 Storing the base station
The base station can, but does not have to be put
into storage. However, the storage prevents pre-
mature ageing, such as fading of the colour, cor-
rosion of the charging contacts and the spring
force terminals.
If the base station remains outdoors:
1. Remove the low-voltage cable from the trans-
former and roll together.
2. Put the transformer into storage.
3. Grease the charging contacts with contact
grease.
When the base station is to be put into
storage:
1. First, carry out all work mentioned above.
2. Disconnect the base station from the bound-
ary cable.
3. Remove the base station and remove any
soiling with a broom and a slightly damp
cloth.
51