Troubleshooting; Appendix; Disposal Of The Appliance - SilverCrest SKF 2300 B2 Mode D'emploi

Troubleshooting

PROBLEM
The appliance does not
function.
oder
GB
The control lamp integrated
into the On/Off switch 0
does not glow.
The appliance has switched
itself off during use and
does not allow itself to be
switched back on.
The green control lamp 9
does not glow.
If the malfunction cannot be corrected with the above suggestions, or if you have determined
that the malfunction may have other causes, please make contact with our Customer Service.

Appendix

Disposal of the appliance

Do not dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2002/96/EC.
Dispose of the appliance through an approved disposal centre or at your com-
munity waste facility. Observe the currently applicable regulations. In case of
doubt, please contact your waste disposal centre.
78
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
The appliance is not connected
with a mains power socket.
The appliance is damaged.
The On/Off switch 0 has not
been activated.
The heat protection function
has been activated.
The heat protection function
has been activated.
The programmed temperature
for the cooking oil/fat has not
been reached.
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
In this case, contact
Customer Services.
Press the On/Off switch 0.
1. Remove the plug and
allow the appliance
to cool down.
2. Press the reset button t
on the rear of the con-
trol/heating element 5.
1. Remove the plug and
allow the appliance to
cool down.
2. Press the reset button t
on the rear of the con-
trol/heating element 5.
Wait a few minutes until the
required temperature has
been reached.
SKF 2300 B2