Removing/Placing Grease Filters - Atag ES9011QM Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

maintenance
removing/placing grease
2
1
1
GB 6
Turn off the ventilator and the lighting and wait 2 minutes to
filters
allow the motor to power down.
Take hold of the grease filter using the handgrip and depress
the catch (1).
Tilt the front side of the filter downwards (2). Now lift the
filter from the hood towards you
The filter can only be put back into place in one way. Take
note of the correct position of the filter (see illustration).
Position the handgrip at the front of the hood.
Put the filter back into place by first pushing the rear side
into the holder. Keep the catch in the handgrip depressed
and simultaneously tilt the front side upwards as far as it
goes and then release the catch. The filter is now once
again in place.

Publicité

Table des Matières
loading

Table des Matières