TROUBLESHOOTING
PROBLEM
Mixer doesn't turn
Gear motor doesn't turn
Beverage leaks from the
container
CAUSE
Drive shaft coupling not cor-
rect
Drive shaft coupling broken
Gear motor not working
Electrical wires disconnected
or interrupted
Product too dense
Motor overheated: "Thermal
Protection" tripped
Stator winding burned out or
interrupted
Rotor shifted
Gears in the reducer box
damaged or worn
Container gasket seal broken
or worn
Tap piston o-ring broken or
worn
Tap piston not in closed posi-
tion
15
SOLUTION
Check that it's in the cor-
rect operating position
Replace mixer and/or drive
shaft
See "Gear motor doesn't
turn"
Connect or replace
electrical wires
Dilute the product
Check the voltage of the
outlet. Check the
ventilation (fins on the side
panels obstructed or lower
part of the distributor
obstructed). Check the
viscosity of the product
Replace the motor
Check the alignment of the
rotor bearings
Replace the motor
Replace gasket seal
Replace the piston o-ring
Check the tap lever or
spring and replace the
worn part