Stihl FS 38 Notice D'emploi page 26

English
Assembling the mowing head
4
2
Fit the empty spool in the mowing
N
head.
If the spring (4) has popped out,
push it into the spool (2) until it
N
engages in position with an audible
click.
Mount the mowing head – see
N
"Mounting the Cutting Attachment".
24
Winding Line onto Spool
3
2
3
5
Use green-coded nylon line with a
N
diameter of 2.0 mm.
Cut two 2 m lengths of line from the
N
replacement reel (special
accessory).
Rotate the spool (2)
N
counterclockwise until the two arrow
points are in alignment.
Push the straight end of each line
N
through one sleeve (5) in the
mowing head (3) until you feel a
noticeable resistance – and then
continue pushing as far as stop.
Hold the mowing head steady.
N
Rotate the spool counterclockwise
N
until the shortest line is about
10 cm.
If necessary, cut the longer line to a
N
length of about 10 cm.
The mowing head is now full.
STIHL AutoCut 5-2
Always check the mowing head for signs
of wear before replacing the nylon line.
WARNING
If there are signs of serious wear,
replace the parts concerned or install a
new mowing head.
FS 38