Stihl FS 38 Notice D'emploi page 16

English
STIHL FixCut 5-2
5
4
3
1
Slip the thrust plate (2) over the
N
shaft.
Place the mowing head on the
N
thrust plate (2).
WARNING
Collar (see arrow) must engage the
mowing head's mounting hole.
Push the thrust washer (3) over the
N
shaft (1) so it is seated on the base.
Block the shaft – see "Blocking the
N
Shaft".
Use the combination wrench (5)
N
(special accessory) to screw the
mounting nut (4) on to the output
shaft clockwise and tighten it down
firmly.
14
NOTICE
Remove the locking pin.
Removing the mowing head
STIHL AutoCut
Hold the mowing head steady.
N
Unscrew the cap counterclockwise.
N
STIHL PolyCut
Block the shaft – see "Blocking the
N
Shaft".
Unscrew the mowing head
N
counterclockwise.
2
STIHL FixCut
Block the shaft – see "Blocking the
N
Shaft".
Use the combination wrench
N
(special accessory) to loosen and
unscrew the mounting nut
counterclockwise from the output
shaft.
WARNING
If the mounting nut turns too freely, fit a
new one.
Adjusting Nylon Line
STIHL AutoCut
2
1
Hold the rotating mowing head
N
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
The blade (1) on the deflector (2)
N
trims surplus line to the correct
length – avoid tapping the mowing
head more than once at a time.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the line is shorter than 2.5 cm:
WARNING
To reduce the risk of injury, always shut
off the engine before adjusting the
mowing line by hand.
FS 38