Assembly - Maytag SkyBox Rookie Fridge MBR1980A Mode D'emploi

Assembly

Attaching The Wheels
The Skybox™ Rookie™ Refrigerator is packaged with
four caster wheels inside the refrigerator. Each wheel is
attached with four screws. Remove wheels and screws
from the packaging and follow the assembly
instructions below.
IMPORTANT: Before attaching the wheels, remove
the Beverage Bin (see page 5) and carefully lay the
refrigerator on its back, with the door facing up. To
prevent scratches, place the refrigerator on flattened
refrigerator carton or other soft surface.
1. Use screws to attach two fixed wheels (without
brakes) to the rear of the refrigerator base. The
wheels must be aligned front-to-back so that the
refrigerator will not roll sideways.
2. Use screws to attach two full-swivel caster wheels
with locking brakes to the front of the refrigerator
base.
Dimensions
The Skybox Rookie™ Refrigerator has the following
dimensions:
35.8"
(909 mm) Height
3
22.7"
(577 mm) Depth
19.8"
(504 mm) Width
2.8 cu. ft. capacity
Installation Location
• This refrigerator is designed for indoor use only
(50 – 80° F/10 – 27° C).
• Allow five inches of clearance between the
refrigerator's sides and the wall. The refrigerator is
not designed for a recessed installation. The door
hinges are on the right side of the unit.
• The refrigerator should be displayed in a secure,
level area.
• Once an installation location is selected, lock front
two wheels of refrigerator in place to prevent the unit
from moving.
• The front wheels lock by pressing the locking arm on
the top of the wheel down until it snaps into place.
• Unlock the front wheels by lifting the locking arm
until it snaps into the raised position.
WARNING
To avoid serious risk of injury, DO NOT lift or move
the refrigerator when loaded, when the Beverage
Bin is loaded, or when the door is open.