Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.3.4 Data backup via the computer
It is possible to save all settings of the amplifier on the computer, either
for data backup or for transfer to another amplifier . For this purpose,
the following menu items are available:
Memory Export Parameters:
to save the current settings to the computer
Memory Import Parameters:
to load the saved settings from the computer
Memory Make Factory:
to save all presets of the amplifier to the computer
Memory Load Factory:
to load all presets of an amplifier from the computer to the
amplifier
7.3.5 Changing the password
As described in chapter 6 .1, a password will protect the amplifier
against unauthorized operation . The password can also be changed
by means of the control program .
Important: Make sure that a data connection to the amplifier has
been established (green indicator "Online" in the lower left corner
of the main window) so that it is possible to save the new password
in the amplifier .
To change the password for the amplifier, call up the menu item
"Security Edit Password" .
When the current password has not been entered since the program
was started or the data connection was established, you will first be
asked to enter the password .
Fig. 10 Password entry request
Fig. 13 View "X-Over, PEQ"
20
Enter the current password and then click "Accept" to confirm . When
an invalid password is entered, the message "Wrong!" will appear:
Confirm the message and re-enter the password .
A new window will appear . Enter the new password in both fields
and then click "Accept" to confirm .
Fig. 11 Changing the password
Another message will appear; confirm this message .
7.3.6 Showing system information
To show the version information of the software and hardware, call
up the menu item "Help About DSP" .
7.3.7 Exiting the program
To exit the program, call up the menu item "File Quit" or close the
main window .
7.4 Configuring signal processing
The main window shows the path the signal takes through the am-
plifier; a more detailed representation can be found in figure 4 on
page 2 . Above the signal path, the blocks used in the main window
are shown . To change settings, click the respective block; a window
with the corresponding view will then appear . To switch from this
view to a different view, click the appropriate block in the upper bar .
When the current password has not been entered since the
program was started, you will first be asked to enter the password
☞
(
fig . 10) . When an invalid password is entered, the message
Publicité
Chapitres
Table des Matières
