Optional Rf Remote Control - Zephyr Tidal II Guide D'utilisation, D'entretien Et D'installation

Features & Controls

Optional RF Remote Control

To order the RF remote control, the part number is 14000005. The blue antenna wire needs to be
extended for optimal signal. Please refer to section, Mounting the Hood, for instructions.
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example -
use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Synchronization
To create a unique link between your hood and remote control please follow these steps.
1. With hood off, press and hold
2. Press a button on the remote, and the remote control will be synchronized with the hood.
RF Remote Control Functions
Blower On/
Blower On/
1
2
Speed Selection
Power Off
3 4
Lights 1/2/3/Off
10 Min Delay Off
26
on the hood until the controls display "REMOTE PAIRING".
Blower On / Speed Selection
1
Press to power on blower and cycle through all six blower speeds.
Blower On / Power Off
2
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
3
By pressing , the blower and lights will enter Automatic Delay Off mode. The
clock icon will illuminate and the controls will display "AUTOMATIC DELAY OFF".
The blower will change to speed 1 and a 10 minute timer will begin counting
down.
Lights 1/2/3/Off
4
Switch between light levels by pressing
the different light levels.
Tidal II Use, Care, and Installation Guide
T I D A L I I
. Turn off the lights by cycling through
P R O
WA L L