Optional Rf Remote Control - Zephyr Roma Pro Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM

Optional RF Remote Control

To order the RF remote control, the part number is 14000005. The blue antenna wire needs to be
extended for optimal signal. If using the RF remote control, remove the light panel to extend the
antenna. There is no need to secure it.
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example -
use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Synchronization
To create a unique link between your hood and remote control please follow these steps.
1. With hood off, press and hold the Lights button on the hood until the controls display "Remote
Pairing..."
2. Press a button on the remote, and the remote control will be synchronized with the hood. The
display will show "Remote Paired" which indicates pairing is complete.
RF Remote Control Functions
Blower On/
1 2
Speed Selection
3 4
Lights On/Dim/Off
10 Min Delay Off
Roma Pro Use, Care, and Installation Guide
Blower On/
Power Off
Blower On / Speed Selection
1
Press
Blower On / Power Off
2
By pressing
again and the entire hood will power off, including lights.
Delay Off
3
By pressing
change to speed 1 and a 10 minute timer will begin counting down.
Lights On/Dim/Off
4
Switch between light levels by pressing
the different light levels.
Features & Controls
to power on blower and cycle through all six blower speeds.
, the blowers will power on at the last speed setting. Press
, the blower and lights will enter Delay Off mode. The blower will
. Turn off the lights by cycling through
19