Electrical Supply; Cable Lock - Zephyr Tidal II Guide D'utilisation, D'entretien Et D'installation

Installation Instructions
ZEPHYRONLINE.COM

Electrical Supply

WARNING
Electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards. Turn off
electrical power at service entrance before wiring.
For personal safety, remove house fuse or open circuit breaker before beginning installation. Do not
use extension cord or adapter plug with this appliance.
Follow national electrical codes or prevailing local codes and ordinances.
This appliance requires a 120V 60Hz electrical supply, and connected to an individual, properly
grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring
must be 2 wire w/ ground. Please also refer to the Electrical Diagram labeled on product.

Cable Lock

A cable locking connector (not supplied) might be required by local codes. Check with local
requirements and codes, purchase and install appropriate connector if necessary. (FIG. A)
Cable Lock
FIG. A
13
Tidal II Use, Care, and Installation Guide