Sony IPELA PCS-TL30 Guide De Démarrage Rapide page 26

System Connections
This section shows some representative system connection
examples.
Besides operating in stand-alone mode, it is also possible
to connect the PCS-TL30 to a computer for use as a display
when no videoconference is in progress. In this case, you
can either use different mice for the computer and the PCS-
TL30, or connect the PCS-TL30 and the computer with a
generic USB cable and use the same mouse for both.
About the connectors
The connectors of the system are located under the rear
cover. Remove the cover to make connections, and then
replace the cover again.
To remove the rear cover
Pull the cover off towards you.
Connector panel
(under rear cover)
To attach the rear cover
Push the cover in while aligning the four stubs.
26
System Connections
Connection precautions
Warning
• Use only the supplied AC adapter and power cord.
• When connecting the power cord of the AC adapter and
the DC cable, insert the plugs fully and securely.
• For safety, do not connect the 100BASE-TX/10BASE-T
connector to a network where excessive voltages may
occur.
Caution
• Before making any connections, be sure to turn power to
all components off.
• To prevent damage to the unit, do not plug in or
disconnect any cable while power to the unit is turned
on.