Publicité
Les langues disponibles
Les langues disponibles
V 4.0
The term cutting accessory is used to represent a cutting blade, cutting wheel
or a cutting bit.
1.
Keep hands away from the cutting area and the cutting accessory.
2.
Only use a cutting accessory of the recommended size (see
Specifications).
3.
Check the cutting accessory for damage before each use. A damaged
accessory can break during use and cause serious injury.
4.
Inspect material for foreign objects such as staples, nails or debris.
Remove from material before cutting.
5.
Do not touch the cutting accessory or the workpiece surface cut with this
tool. They may be hot and could inflict a burn injury.
DRILLING PRECAUTIONS
The term bit refers to any drill bits, router bits or tool accessories that penetrate
a material and creates a cavity through a rotary motion.
1.
Never force the tool's bit. Forcing the tool will slow down the cutting speed of the
bit, causing it to bind. Apply gentle pressure and allow the bit to do the cutting.
2.
Do not use a bit with a dull or damaged cutting edge. Keep the cutting edge
sharp and clean. A dull bit may cause the tool to skitter across the work
surface instead of penetrating the material. This may cause an injury and
will damage the workpiece.
3.
Hardened gum and wood pitch on a bit slows the tool down and increases
the potential for binding. Remove the bit from the tool, then clean it with
hot water, kerosene or gum and pitch remover. Never use gasoline. Allow
to dry before using. Discard the bit if the gum or pitch cannot be removed.
4.
Do not apply side pressure on the bit unless it is designed for such a
purpose. The bit may bind or break.
5.
A loose or mismatched cutting bit may be ejected by the tool, causing an
injury to the user or a bystander. It may also fail to penetrate the material,
as the point may move around under pressure, damaging the workpiece.
a.
Ensure the cutting bit shank size matches the tool's chuck or collet size.
b.
Tighten the chuck or collet so the shank is tightly held with no room
to move.
Visit www.princessauto.com for more information
12 in. Variable Speed Bench-Top Drill Press
8654345
7
Publicité
