Publicité
Les langues disponibles
Les langues disponibles
8654345
3.
Keep all connections dry and off the ground to reduce the risk of electric
shock. Do not touch plug with wet hands.
4.
Prevent damage to the power cord by observing the following:
a.
Do not pull on the cord to disconnect the plug from an outlet.
b.
Keep cord away from heat, oil, sharp edges or moving parts.
5.
Do not allow people, mobile equipment or vehicles to pass over
unprotected power cords.
a.
Position power cords away from traffic areas.
b.
Place cords in reinforced conduits.
c.
Place planks on either side of the power cord to create a protective trench.
ELECTROMAGNETIC FIELDS FOR DEVICES
WARNING! Shut off the electrical tool or device and move away if you feel
faint, dizzy, nausea or shocks. Seek medical attention.
Electromagnetic Fields (EMF) can interfere with electronic devices such as
pacemakers. Anyone with a pacemaker should consult with their doctor before
working with or near a tool that generates an EMF. The following steps can
minimize the effects of electromagnetic fields.
1.
Keep the power source and any power cables as far away from the user as
practical. A minimum of 24 in. is recommended.
2.
Avoid long and regular bursts of energy while operating the tool. Use the
tool for short or intermittent periods of time. This will prevent a pacemaker
from interpreting the signal as a rapid heartbeat.
3.
Alert other people in the work area, so they can take precautions or can
watch out for those with a pacemaker.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
10
12 in. Variable Speed Bench-Top Drill Press
For technical questions call 1-800-665-8685
V 4.0
Publicité
