Publicité
DEFAULT CONFIGURATION
PARAMETERS
At the beginning of configuration procedure,
when the display shows "COnF", it is
possible to load the default data for
configuration parameters.
When this action is desired, proceed as fol-
lows:
1) Push L and M pushbutton at the same
time; the display will show "dF.OF"
2) Push the L pushbutton, the display will
show "dF.On".
3) Push F to load the default data; during the
loading procedure the display will show
"LOad".
DEFAULT CONFIGURATION PARAM-
P1
= 1
P2
= 0
P3
= -1999 Low scale value for linear
P4
= 4000 Full scale value for linear
P5
= 0
P6
= OFF Alarm 1 function : disabled
P7
= rEv
P8
= OFF Alarm 1 stand by disabled
P9
= No
P10 = LSV
2 rue René Laennec 51500 Taissy France
E-mail:hvssystem@hvssystem.com
Fax: 03 26 85 19 08, Tel : 03 26 82 49 29
Site web : www.hvssystem.com
P11 = 0.1% Alarm 1 hysteresis
P12 = OFF Alarm 2 function : disabled
P13 = rEv
P14 = OFF Alarm 2 stand by : disabled
P15 = OFF Alarm 3 function : disabled
P16 = rEv
P17 = OFF Alarm 3 stand by : disabled
P18 = 0
P19 = 0
P20 = 0
P21 = OFF No analog retransmission
P22 = -100 Analog retransmission - initial
P23 = 1000 Analog retransmission - full
ETERS
input TC J (-100/ 1000 °C)
No decimal point
input
input
Digital filter disabled
Alarm 1 type : reverse
Alarm 1 threshold and
hysteresis are displayable
and modifiable during run
time.
Alarm 1 threshold : Low scale
value
Appendix A.1
Alarm 2 type : reverse
Alarm 3 type : reverse
Delay on the alarm stand by:
disabled
No offsett on the measured
value
Safety lock : unlocked
scale value.
scale value.
Publicité
