EUROM Q-Time 2001 Manuel D'utilisation page 24


Only connect the heater to an earthed socket! For personal protection the
installation, to which the Q-Time 2001 is connected, has to be equipped with an
earth fall device (max. 30 mA).
Permanent mounting
The Q-Time 2001 is designed for installation in a permanent position and direct
connection to the electricity network. For safety reasons, this installation should be
fitted by an approved electrician.
Plug connection
The Q-Time 2001 can also be connected directly to a power socket using the electric
cable and plug. Make sure that the electric cable does not hang over any (sharp)
edges, does not make any sharp angles, cannot be dragged and does not touch any
hot surfaces.
Important: the electric cable and plug form a whole. Therefore, if either the electric
cable or plug is damaged they should both be replaced by an electrician. Only mount
the original parts!

When positioning and connecting the heater, make sure that your hands do not
touch the heating elements. This is because traces can be left behind which,
afterwards, will have a negative effect on the radiated heat.

For use with a plug, the following applies: do not use extension leads and do not
connect any other equipment next to the heater in the same socket!

Position the mounting bracket (A) with the side with 2 holes against the wall in
the required position, then mark the drill holes. Make sure that the drill holes are
positioned at the same height!
Remove the bracket and drill 2
holes in the spots marked. Knock
in the raw plugs, position the
bracket over the top and screw it
firmly into the wall using the
screws supplied.

Place the heater over the bracket
with the cord down and large
holes positioned over large holes.
Screw securely using the bolts
and nuts supplied (B).

Turn the heater to the required
position. The body of the heater
can be turned to 2 positions (small heater holes over one of the two small
bracket holes (C)). Secure the heater at the required angle by screwing both of
the small screws into the double holes.

The heater is now ready for use.
24