Lennox RELAX Manuel Du Propriétaire page 15

TIMER Operation
TIMER ON button can set the auto-on time of the unit.. TIMER OFF button can set the auto-off time of
the unit.
1. To set the starting time.
1.1 Push the TIMER ON button, then the remote controller shows TIMER ON , the last set time for
the starting operation and the signal "h" will be shown on the DIGITAL DISPLAY area. You are
now ready to reset the time to START the operation.
1.2 Push the TIMER ON button again to set desired unit start time.
1.3 After setting the TIMER ON ,there will be a one-half second delay before the remote controller
transmits the signal to the air conditioner. Then, after approximately another 2 seconds, the
signal "h" disappears and the set temperature will re-appear on the digital display.
2. To set the stopping time.
2.1 Push the TIMER OFF button and the remote controller will show TIMER OFF, the last set time
for the stopping operation and the signal "h" will be shown on the DIGITAL DISPLAY area.
You are now ready to reset the time of the STOP operation.
2.2 Push the TIMER OFF button again to set the time you want to stop the operation.
2.3 After setting the TIMER OFF ,there will be a one-half second delay before the remote controller
transmits the signal to the air conditioner. Then, after approximately another 2 seconds, the signal
"h" disappears and the set temperature will re-appear on the digital display.
3. Set the starting & stopping time
3.1 Push the TIMER ON button, the remote controller will show TIMER ON, the last set time for
START operation and the signal "h" will be shown on the DIGITAL display area. You are now
ready to readjust the TIMER ON to start the operation.
3.2 Push the TIMER ON button again to set the time you want to start the operation.
3.3 Push the TIMER OFF button, the remote controller will show TIMER OFF, the last set time for
STOP operation and the signal "h" will be shown on the DIGITAL display area. You are now
ready to reset the time to STOP operation.
3.4 Push the TIMER OFF button again to set the time you want to stop the operation.
3.5 After setting the TIMER, there will be a one-half second delay before the remote controller
transmits the signal to the Air Conditioner. Then , after approximately another 2 seconds, the
set temperature will re-appear on the digital display.
Change the TIMER
To change the TIMER ON/OFF time, just press the corresponding TIMER button and reset the time.
NOTE
The setting time is relative time. That is the time set is based on the delay of the current time.
Warning
1. Be sure there are no obstacles between the remote controller and the receiver of indoor unit
otherwise the air conditioner will not work.
2. Keep the Remote Controller away from any liquids.
3. Protect the remote controller from the high temperatures and exposure to radiation.
4. Keep the indoor receiver out of direct sunlight or the Air Conditioner may malfunction.
5. Keep Remote Controller away from EMI(Electro-Magnetic Interference) supplied by other
household appliances.
6. When replacing batteries, do not use old batteries or a different type battery. This may cause the
remote control to malfunction.
7. If you do not use the remote controller for several weeks remove the batteries. Otherwise battery
leakage may damage the remote controller.
8. The average battery life under normal use is about 6 months.
9. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission
Indicator light fails to light.
11