DJO ARTROMOT-K1 Standard Mode D'emploi page 60

n Total therapy time
ARTROMOT® K models without
chip card
The total therapy time is the added sum
of operating hours.
If the device is used by only one patient,
this time is equivalent to the duration of
all the patient's therapy sessions.
Under menu item "total therapy time"
of ARTROMOT® K models with chip
card, you can view each patient's total
therapy time duration of all the pa
tient's therapy sessions .
Deleting the stored therapy time
Press and hold the parameter button
for seconds or select the New Patient
function.
LEVEL :
n Transport setting
With this function, the carriage will move
to a position optimally suited for packing
the CPM device. Adjust the femur length
to cm and the tibia length to
Select the function and press the START
button. The carriage moves to the trans
port position. Also refer to . .
n New patient
With this function, the CPM device will
move to the home position, allowing the
mechanical settings to be completed.
Select the function and press the START
button. The carriage moves to the home
position.
With ARTROMOT® K devices with
patient chip card, the factory defaults
will be restored. All stored values will
be deleted. The carriage will stop in the
home position.
The New Patient home position func
tion selects the following settings:
− Extension:
− Flexion:
− Speed:
− Warm up:
Extension pause:
Flexion pause:
− Timer:
n Therapy documentation
cm.
n Service MENU
Reminder:
You save the selected parameter values by
pressing the STOP button.
°
°
%
disabled
continuous
operation
− Load reversal:
− Total therapy time:
Stretching in extension: disabled
Stretching in flexion:
− EROM repeat
extension:
− EROM repeat
flexion:
− Comfort protocol:
− Workout protocol:
− EMS control:
Therapy
documentation:
ARTROMOT® K devices of the Com
fort series with patient chip card have
a special documentation function
which provides a log of all therapy
sessions. The device run times as well
as the range of motion of the sessions
are recorded. The collected data are
presented graphically in the form of a
coordinate system X axis = range of
motion / Y axis = time where the upper
curve illustrates the trend of the flexion
movement and the lower curve the
trend of the extension movement.
For service purposes only,
refer to Service Manual.
disabled
disabled
disabled
disabled
disabled
disabled
reset