DJO ARTROMOT-K1 Standard Mode D'emploi page 54

− For a uniform, smooth and gentle
transition between the two directions
of motion, the speed is automatically
reduced before reaching the reversal
point and, on reaching the reversal
point, it is continuously increased
until it reaches the set speed.
Patients with a programmed
chip card
− Insert the chip card the patient is not
yet positioned on the unit .
− Perform the mechanical adjustments
femur length, etc. .
− Place the patient on the CPM device
and press the START button to initiate
therapy.
. Programming
ARTROMOT® K Standard
models
Different programming levels are provided
to program the ARTROMOT® K Standard
models.
You change between levels by pressing the
MENU button.
The display always indicates the currently
selected level.
The following treatment values, settings
and information can be entered/viewed
on the control pendant
LEVEL :
− Extension
stretching the knee
− Flexion
bending the knee
Speed
Warm up protocol
LEVEL :
Extension pause
Flexion pause
:
MENU
− Timer therapy time
− Reverse on load
feature for patient safety
LEVEL :
Transport setting
New patient
Total therapy time
Service menu
Note!
− While you adjust the extension/flex
ion values, the carriage will move to
the set range. This allows you to easily
and quickly determine the ROM where
the patient does not experience pain.
− Special functions can be programmed
and retrieved with ARTROMOT® K
Comfort devices see sections .
and . .
− Only ARTROMOT® K chip card
models allow therapy protocols to be
saved to an inserted chip card.
. Treatment value details
Standard models
− You access the different programming
levels by repeated depressions of the
MENU button.
− You select the treatment parameters
with the corresponding parameter
button.
− You change the treatment values with
the +/− buttons and you enable/disable
functions by pressing the corresponding
parameter button again.
− You save the settings by pressing the
STOP button.
MENU