DJO ARTROMOT-K1 Standard Mode D'emploi page 59

the programmed extension value. When
the extension value has been reached,
the carriage reverses
flexion angle and then moves back
again to the maximum extension value.
The movement through the final
repeated times at a slow speed.
At the end of the cycle, the carriage will
again move to the maximum flexion
value and then starts another cycle with
repetitions through the last
extension angle.
n EROM
repeat flexion
The special "EROM repeat flexion" func
tion allows a more efficient exercise in
the last ° before the set maximum
extension value.
For this protocol, the CPM device starts
midway between the set extension and
flexion values. It will first move to the
programmed extension value and then to
the programmed flexion value.
When the flexion value has been reached,
the carriage reverses
tension angle and then moves back again
to the maximum flexion value. The move
ment through the final
times at a slow speed.
At the end of the cycle, the carriage will
again move to the maximum extension
value and then starts another cycle with
repetitions through the last
flexion angle.
n EMS control
This special function allows the
ARTROMOT® K Comfort device to be
operated in conjunction with the elec
trical muscle stimulator ARTROSTIM®
FOCUS®plus, for which it is ideally suited.
For this modality, first plug the "muscle
stimulation" connection cable part
no. . . into the ARTROSTIM®
FOCUS®plus device see ARTROSTIM®
FOCUS®plus instructions for use and
then into the ARTROMOT® K Comfort
device see . .
Then activate the EMS control program
at the ARTROMOT® K Comfort.
This function will select the following
settings:
− Extension: as per your protocol
° toward the
° is
° of the
° toward the ex
° is repeated
° of the
− Flexion: as per your protocol
− Extension pause:
Flexion pause: seconds
Note!
All other protocols will be disabled or
reset to the default values.
Start therapy by pressing the START
button. Starting from the middle
position, the carriage will move to the
programmed flexion angle, then to the
programmed extension setting.
At this point, the carriage will stop and
simultaneously send a trigger pulse to
ARTROSTIM® FOCUS®plus.
For the duration of the pause default:
seconds , the muscle stimulation
protocol that you programmed at the
ARTROSTIM® FOCUS®plus will be com
pleted with the selected intensity for
programming of the EMS device, see:
ARTROSTIM® FOCUS®plus instructions
for use .
After the pause, the ARTROMOT® K
will turn off the EMS device and the
carriage moves to the programmed
maximum flexion angle.
The electrical muscle stimulation will be
repeated in the next extension pause.
Note!
− After activation of the special "EMS
control" function, the pause settings
can be changed.
− Electrical muscle stimulation can only
take place during extension pauses.
Caution!
Patient hazard
The only approved device for electrical
muscle stimulation is the ARTROSTIM®
FOCUS®plus muscle stimulator with
EN approval, available from
ORMED GmbH.
seconds