DJO ARTROMOT-K1 Standard Mode D'emploi page 56

LEVEL :
n Transport setting
With this function, the carriage will
move to a position optimally suited for
packing the CPM device. Adjust the fe
mur length to cm and the tibia length
to cm. Select the function and press
the START button. The carriage moves
to the transport position. Also refer to
. .
n New patient
With this function, the CPM device will
move to the home position, allowing the
mechanical settings to be completed.
Select the function and press the START
button. The device enters the home po
sition and existing therapy parameters
will be deleted.
With ARTROMOT® K devices with
patient chip card, the factory defaults
will be restored. All values stored on the
chip card will be deleted.
The carriage will stop in the home
position.
The "New Patient" function home
position selects the following settings:
− Extension:
− Flexion:
− Speed:
− Warm up:
Extension pause:
Flexion pause:
− Timer:
operation
− Load reversal:
− Total therapy time:
n Total therapy time
ARTROMOT® K models without
chip card
The total therapy time is the added sum
of operating hours. If the device is used
by only one patient, this time is equiva
lent to the duration of all the patient's
therapy sessions.
Under menu item "total therapy time"
of ARTROMOT® K models with chip
n Service MENU
Reminder:
You save the selected parameter values by
pressing the STOP button.
ARTROMOT® K devices of the Comfort
series offer two more programming levels
for additional functions.
The programming levels are selected in the
same way as on Standard models.
Programming levels and
with programming levels and
Standard models.
°
With the default settings all special func
°
tions are disabled.
%
The following treatment values, settings
and information can be entered/viewed
disabled
on the control pendant
LEVEL :
continuous
− Extension
− Flexion bending the knee
LEVEL :
card, you can view each patient's total
therapy time duration of all the pa
tient's therapy sessions .
Deleting the stored therapy time
Press and hold the parameter button
for seconds or select the New Patient
function.
For service purposes only,
refer to Service Manual.
. Programming
ARTROMOT® K
Comfort models
stretching the knee
Speed
Warm up protocol
Extension pause
Flexion pause
are identical
of the
:
MENU