Grizzly Tools BRM 4013 Traduction De La Notice D'utilisation Originale page 80

GB
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as possible.
For uninterrupted mowing, the lines
should always overlap by a few centi-
metres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with a
foreign body, switch off the engine im-
mediately. Wait until the blade is station-
ary and check the equipment for dam-
age. Restart work only if the equipment
is undamaged.
• Switch off the equipment during longer
breaks and for transportation and wait
until the blade is stationary.
• Clean the equipment after each use, as
described in the "cleaning and mainte-
nance" chapter.
Setting the Cutting
Height
The equipment has 6 positions for set-
ting the cutting height (25-35-45-55-65-
75 mm):
1. Unscrew the wheels (12).
2. Screw the wheels (12) back into the
desired place. All wheels must be set
to the same height.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Select a greater cutting height for
the first cut of the season.
80
Cleaning and
Maintenance
Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
Cleaning and General
Maintenance Work
Tilt the device back for cleaning
and maintenance jobs at the bot-
tom side so that the spark plug
faces upwards.
Make sure that a second person
holds the device because there is
a danger of tipping backwards.
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
• Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine
as it could contaminate the fuel sys-
tem.