Publicité
Les langues disponibles
Les langues disponibles
Maintenance and Storage:
• Ensure that all nuts, bolts and screws
are tightened firmly and the equipment
is in safe working condition. Many
accidents are caused by poorly main-
tained equipment.
• Do not keep the equipment with petrol
in the tank inside a building in which
petrol fumes could potentially come
into contact with open fire or sparks.
• Allow the engine to cool before plac-
ing the equipment in enclosed spaces.
Risk of fire.
• To avoid the risk of fire, keep the en-
gine, exhaust and area around the fuel
tank free of grass, leaves or leaking
grease (oil).
• Check the grass catcher regularly for
wear or loss of function.
• For reasons of safety, replace worn
or damaged parts. Replace defective
silencers.
• If the fuel tank is to be drained, do this
outdoors.
• Handle your equipment with care.
Keep the tools sharp and clean to ena-
ble you to work better and more safely.
Follow the maintenance directions.
• Do not attempt to repair the equipment
yourself unless you are trained to do
so. Any work not specified in these
instructions is to be carried out only by
customer service centres authorised
by us.
• Keep the equipment in a dry place and
out of reach of children. Machines are
dangerous if used by inexperienced
people.
Initial Operation
Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Before starting the device, you must
- mount the grip rod,
- fill in motor oil,
- fill in petrol,
- mount the grass catcher if necessary,
- set the cutting height if necessary.
Mounting grip rod
Mounting the lower bars:
1. Insert the lower bars (5) into the
mount on the lawnmower hous-
ing.
2. Fasten the lower bars (5) using
the enclosed screws (5a).
Mounting the bow-type handle:
3. Screw the upper grip (1) to the
right and left of the lower han-
dlebars (4) using the included
quick-release levers and nuts
(25).
4. Attach the bow-type handle (1)
to the lower bars (5) using the
enclosed screws and knurled
nuts (4a).
Fitting the wheels
1. Slide the wheel screw joints (12a)
through the middle hole of the wheels
(12).
2. Screw the wheels (12) into the desired
place. All wheels must be set to the
same height. There are three possible
positions.
GB
77
Publicité
