Sherco 250 SE RACING Manuel page 139

ELECTRICAL SYSTEM MAINTENANCE
REPLACING THE MAIN FUSE
REPLACING THE FUSE FOR THE LIGHTS
REMOVING THE HEADLIGHT HOUSING
1
2
Remove the seat ( p.120).
The main fuse
Remove the defective fuse and replace with a new fuse
of the same value.
Main fuse 30A
Put a new spare fuse in the reserve location in the
fuse box.
1
- Replace the seat ( p.120).
Remove the seat ( p.116).
The light fuse
wiring harness on the right side of the bike.
Remove the defective fuse and replace with a new fuse
of the same value.
Light fuse
- Replace the seat ( p.116).
1
Wait 30 second ignition to turn off .
Unclip the left and right rubber fastners
side of the fork.
Separate all of the brake hoses / cables from the meter
bracket at the top and bottom.
Move the top plate up to clear the housing.
Disconnect the connector
housing.
is on a relay by the starter.
1
is located in a high location on the
1
and remove theheadlight
2
30A
15A
on each
1
139