Sherco 250 SE RACING Manuel page 105

COOLING SYSTEM
3
DRAINING THE COOLANT
1
2
Check the fluid level in the expansion container.
The liquid should reach the level on the container
where it indicates "LEVEL MIN".
If the level is not correct, unscrew the cap
Fill with fluid until it reaches the LEVEL MIN mark.
Coolant
Replace the cap .
3
WARNING
Make sure the bike is vertical and on a horizontal surface.
- Place a container under the bike.
- Remove the cap and screw
1
- Allow the coolant to drain.
NOTE
To protect the environment deposit the drained coolant at an
approved collection center.
.
3
Motul ® Motocool
Factory Line -35°C
.
2
105