Sherco 250 SE RACING Manuel page 106

COOLING SYSTEM
FILLING THE COOLANT
2
3
1
106
- Replace the bleed screw
- Refill the coolant into the radiator through the
cap .
1
Coolant
- Fill coolant until is going out from the screw
- Put the screw back in with a new seal.
3
Radiator bleed screw
- Continue filling.
- Fill until the coolant reaches the level (approximately
1.1 liters).
- Put the bike on the side stand and follow the rest
of the filling procedure ( p.104).
- Replace the cap .
1
using a new gasket.
2
Motul ® Motocool
Factory Line -35°C
.
3
M6X45 8Nm