Belkin OmniView F1DE101HEA Manuel De L'utilisateur page 58

4-5 Device Settings
Dynamic DNS
A freely available Dynamic DNS service (dyndns.org) can be used in the
following scenario:
Dynamic DNS Scenario
You can reach the RIPM via the IP address of the DSL router, which is
dynamically assigned by the provider. Since the administrator does not know
the IP address assigned by the provider, the RIPM connects to a special
dynamic DNS in regular intervals and registers its IP address there. The
administrator may contact this server as well and pick up the same IP address
belonging to the NIC. The administrator must register a RIPM to use the service
with the dynamic DNS and assign a certain host name to it. A username
and password will be assigned during the registration process. This account
information together with the host name is needed in order to determine the IP
address of the registered RIPM.
You must perform the following steps in order to enable dynamic DNS:
• Make sure that the LAN interface of the RIPM is properly configured.
• Enter the dynamic-DNS-settings-configuration dialog as shown on page 55.
P75075ea_F1DE101Hea_man.indb 54
Menu Options
8/16/2006 11:33:22 AM
1
2
3
4
5
6
54