Belkin OmniView F1DE101HEA Manuel De L'utilisateur page 41

4-2 Virtual Media
Step 3: Click "Re-Activate" in the Active Image section.
Step 4: Enter the IP Address provided by the drive re-direction software into the
Step 5: Enter the "Share name" and the "Path to Image."
Step 6: To upload the file, click the "Set" button. The file will be displayed as a
The specified image file should be accessible from the RIPM. The information
above must be given from the point of view of the RIPM. It is important to specify
correct IP addresses and device names. Otherwise, the RIPM may not be able to
access the referenced image file properly and will leave the given file un-mounted
(displays an error message instead). Belkin recommends that you use the correct
values and repeat this step, if necessary.
The specified share must be configured correctly. Therefore, administrative
permissions are required. As an ordinary user, you may not have these
permissions. You should either log in as a system administrator or ask your
system administrator for help to complete this task.
37
P75075ea_F1DE101Hea_man.indb 37
"Share Host " field.
USB device on the remote computer.
Menu Options
8/16/2006 11:33:15 AM