Rocks
•
Remove small rocks (lower than
100 mm) from the lawn area. These
may damage the device and the
blades (26).
•
The automatic lawn mower detects
rocks (taller than 100 mm) as normal
obstacles.
We recommend using the boundary
wire (6) to also border rocks.
Gradients
The automatic lawn mower is able to
traverse uphill gradients up to max. 20°
(35%).
The boundary wire should not be installed
across uphill gradients greater than 20°
and downhill gradients greater than 10°
(17%).
Make sure that a distance of at
least 30 cm is maintained between
the boundary wire (6) and an ob-
stacle on an uphill gradient and at
least 40 cm on a downhill gradient.
Ponds/pools
Ponds and pools should be bordered by
the boundary wire (6) where possible
or designed so that the automatic lawn
mower cannot enter the water. This may
seriously damage the device's electronics.
Paths/roads
The automatic lawn mower can easily
cross paths and roads at ground level.
If height differences exist between the
lawn area and path/road, border off the
path/road with a safety margin of approx.
40 cm.
Narrow passages
Narrow passages on the bordered lawn
area should be at least 1.2 m wide and no
more than 8 m long (see figure
Connecting the boundary
wire to the charging
station
1. Strip approx. 10-15 mm of both ends
of the boundary wire (6) using cable
strippers.
2. Connect the rear end of the bound-
ary wire (6) to the contact jack (31)
marked with "S1".
3. Pass the other end of the boundary
wire (6) through the groove (32) under
the charging station (12).
4. Connect this end of the wire to the
contact jack (30) marked with "+".
5. Check the LED (28) on the charging
station.
If the LED (28) lights up green, the
boundary wire (6) is connected to the
charging station (12) correctly.
Allow a metre of additional space
for corrections when installing the
boundary wire (6).
Do not place the "protruding"
remains of the boundary wire
together. This can lead to faults
and failures in the automatic lawn
mower's operation.
Switching on and off
Switching the automatic lawn mower
on
1. Press the on/off switch (5) on the un-
derside of the automatic lawn mower
(position "1").
GB
m
).
103