Hendi KitchenLine 238905 Mode D'emploi page 9

Faults
Fault
Appliance does not
do anything
Appliance does not
do anything
Appliance does not
reach the set
temperature..
1) Reset overload circuit breaker
- Allow the Bain marie to cool down.
- Remove the water from the tank.
- Press the brass reset button of the overload circuit breaker at the bottom at the appliance. You
should hear a clear click.
- The Bain marie is now ready to be used again
Warranty
Any defect affecting the functionality of the appliance that becomes apparent within one
year after purchase will be corrected by free repair or replacement provided the appliance
has been used and maintained in accordance with the instructions and has not been
abused or misused in any way. Your statutory rights are not affected. If the appliance is
claimed under warranty, state where and when it was bought and include proof of
purchase (f.e. receipt).
In line with our policy of continuous product development we reserve the right to change
the product, packaging and documentation specifications without notice.
Discard & Environment
At the end of the life of the appliance, please dispose of the appliance according to the regulations
and guidelines applicable at the time.
Throw packing materials like plastic and boxes in the appropriate containers.
Symptom
green switch light does
not light and the green
control light does not light
green control light does
not light
green control light does
not go out
Cause
No power at the
power point
Overload circuit
breaker tripped
Thermostat defective Replace the thermostat
Element defective
Possible solution
Check the electrical
installation
Reset the overload circuit
breaker ( 1 )
Replace the element