Publicité
Les langues disponibles
Les langues disponibles
Oil Filter
RISK OF INJURY! The unit consists of rotating and pressurized components. Do
not attempt to change oil until the unit has completely stopped and been fully
depressurized.
RISK OF BURNS! The unit parts, oil, and screw plug can be hotter than 175° F
(80° C)! Wear personal safety equipment!
NOTE: Replace the oil filter with every oil change.
1. Switch off the screw compressor system and prevent it from being switched back on without authorization.
2. Depressurize the system completely.
3. Remove the oil filter cartridge with a suitable tool, e.g. oil filter strap wrench.
Dispose of the old oil filter cartridge in accordance with the applicable
regulations.
4. Oil the seal on the new oil filter cartridge
with oil of the same oil type as in the air
end.
5. The new oil filter cartridge must be held
vertically and filled with oil of the same oil
type as in the compressor module before
being screwed on.
6. Screw the new oil filter cartridge onto the
multiblock and tighten by hand. No tool is
required.
7. Switch on the system.
8. The oil filter must then be checked for
leaks with the system running.
9. Check the oil level as explained earlier
and top up the missing oil quantity again
to the maximum level.
Air-Oil Separating Element
RISK OF INJURY! The unit consists of rotating and pressurized components. Do
not attempt to change oil until the unit has completely stopped and been fully
depressurized.
RISK OF BURNS! The unit parts, oil, and screw plug can be hotter than 175° F
(80° C)! Wear personal safety equipment!
Heavily soiled intake air or low-quality oil cause heavier soiling of the cartridge,
which can result in the premature need for replacement.
1. Switch off the screw compressor system and prevent it from being switched back on without authorization.
2. Unscrew the air-oil separating element with a suitable tool, e.g. oil filter strap wrench.
Dispose of the used oil, oil-contaminated container, and cloths in accordance with
local regulations.
3. Oil the seal on the new air-oil separating
element with oil of the same oil type as in
the compact module screw compressor.
4. Tighten the new air-oil separating element
by hand. No tool is required.
5. Switch on the compressor system.
6. The air-oil separating element must be
checked for leaks with the system running.
Oil Filter
Figure 12 - Oil Filter
Air-Oil
Separating
Elements
Figure 13 - Air-Oil Separating Element
Multiblock
Filter Seal
19
Publicité
