Alpine PXA-H800 Manuel Supplémentaire page 6

Preset Data Call Operation upon Initial
Start-up
With Ver.1.100 and Ver.2.100, preset data saved on the unit can be
called up at the first start-up after battery power has been disconnected
once.
If an Ai-NET compatible head unit is connected, preset data can also be
called up from the head unit.
• To call up preset data from the head unit, refer to the Owner's
Manual of the head unit. After calling up the data, turn the ignition
key to the OFF position, and then turn it back to the ON position.
Until this procedure has been performed, the settings will not be
applied, and audio will not be output.
<From a PC>
1
When Sound Manager for PXA-H800 is started up for
the first time, click [Call] for "Preset" on the
message screen.
2
Click one from [Preset 1] to [Preset 6], and then click
[OK].
3
Click [OK] when a confirmation message appears.
Exit Sound Manager for PXA-H800. Turn the ignition key to
off, and then on again. The settings become effective.
4
-EN
<From the Commander>
1
For first time startup, press the [Rotary encoder] or
[FUNC.].
2
Rotate the [Rotary encoder] to select "Preset," and
then press the [Rotary encoder].
3
Select a preset from "P.1" through "P.6" by rotating
the [Rotary encoder], and press the [Rotary
encoder].
The "Turn ACC Off" screen will be displayed. Turn the
ignition key to the OFF position, and then back to the ON
position again. The settings become effective.
Addition of Preset Memory Items
Navigation audio guidance interrupt ON/OFF setting and Navigation
audio guidance volume adjustment have been added to the items to be
stored in preset memory.
• The following item has been added to the list of preset items
in "Storing the Preset Values (Preset Store)" (page 12) in the
Owner's Manual – PC guide.
Setting/Adjusting the Navigation Guidance
Volume (Navi Mix)
• The following item has been added to the list of preset items
in "Storing the Preset Values (Preset Store)" (page 36) in the
Owner's Manual – Commander guide.
Mixing Navi Audio Guidance (Navi Mix Setup)
Subwoofer Level Adjustment when Ai-NET
is Connected
If the software is updated to Ver.2.100, subwoofer level can be adjusted
using the PC software or Commander when any of the below Ai-NET
compatible head units is connected. For details on operation, refer to
"Audio Adjustment"-"Adjusting Subwoofer (SubW Lv)" (page 12),
"Audio Adjustment"-"Adjusting Subwoofer (SUBWOOFER)" (page
35) in the Owner's Manual – PC or Commander guide.
iDA-X301/ iDA-X301RR/ iDA-X311/ iDA-X311RR/ iDA-X305/ iDA-
X305S/ CDA-9884R/ CDA-9885R/ CDA-9886R/ CDA-9887R/
CDA-105Ri/ DVA-9965R/ iXA-W407BT/ iXA-W404R
Page 16
Page 41