Selectable Functions - Enabling And Disabling Procedures - Cobra SPYBALL 6808-9 Notice De Pose

4. Once the appropriate sensitivity level has been selected, turn ignition
off, then turn it on immediately
confirms you have entered the procedure of adjustment of the
sensitivity to shock.
5. Operate as described at pos. 3).
6. Once the appropriate sensitivity level has been selected, turn ignition
off. A sharp audible signal confirms you have quit the selection
procedure.
To test the movement sensor and determine the optimal sensitivity level
more easily, you can simulate displacement / shock before quitting the
procedure; if the sensitivity is sufficient to trigger the unit, you will get a
sharp audible signal (instead of a full alarm cycle).
Remarks:
•
To ensure accurate adjustment, avoid generating shocks while selecting
the level of sensitivity to displacement.
•
It is recommended to evaluate the optimal sensitivity levels once both
adjustments have been set, before quitting the procedure.
5. SELECTABLE FUNCTIONS – ENABLING AND DISABLING
PROCEDURES
The functions listed below are selectable, that is they can be enabled or
disabled as chosen by the user. The set-up is stored until the next time a
different configuration is selected.
- Biker Recognition (see paragraph 3 of user manual and remark in bold
below)
On/off audible signals (see paragraph 4 of user manual) and panic
-
function (see paragraph 9 of user manual)
- "Turn indicator on" audible warning signal (see paragraph 13 of user
manual)
Anti-hijack function (see paragraph 10 of user manual and remark in
-
bold below)
- Polarity of instantaneous alarm trigger input (this selection shall be
operated by the installer and shall not be altered by the user after the
security system has been fitted).
Remark: to enable / disable the Biker Recognition and Anti-Hijack
functions, it is necessary to operate also on the transmitter as
described in paragraph 3.1 of the user manual.
SPYBALL 6808-9/6828-9 ENGLISH
again. A deep audible signal
17