Wiring Instructions - Cobra SPYBALL 6808-9 Notice De Pose

Once all connections are completed, secure the unit firmly, by means of the
supplied bolts and nuts and/or fitting wings, as appropriate for each specific
application (see also picture A underneath).
Always fit the red round rubber gaskets (vibration absorbers) between the
fitting wings and/or the bolt heads and the surface the unit is in touch with). If
the unit is placed on a flat surface, you can use adhesive velcro tape (not
supplied).
2.1. Siting of the LED
The LED performs the following functions:
visual deterrent
-
visual indication of alarm status
-
- emergency override function in conjunction with the motorcycle ignition
switch.
It should be sited in a visible location, preferably on the instrument board. To
fit the LED, drill a 10mm hole, ensuring that the panel is free from obstruction
and protecting any wiring enclosed. The pre-wired LED is then pushed fully
home into the hole.

3.WIRING INSTRUCTIONS

- If you are using a STANDARD WIRING HARNESS, follow the
instructions herebelow. All the connections should be soldered and
insulated. Remark: the cable harness is available with multi-colour wires
or with one-colour numbered wires (the small numbers printed at the
ends of the wires have to be removed upon installation). The table
herebelow shows both the colours and the numbers.
SPYBALL 6808-9/6828-9 ENGLISH
ILL. A
13