Manitowoc RF Serie Mode D'emploi page 26

Maintenance
Air-Cooled Condenser Cleaning
!
Disconnect electric power to the ice machine and
the remote condenser at the electric service switch
before cleaning the condenser.
A dirty condenser restricts airflow, resulting in
excessively high operating temperatures and reduced
ice production. Clean the condenser at least every six
months.
! Caution
The condenser fins are sharp. Use care when
cleaning them.
1. Clean the outside of the condenser with a soft brush
or a vacuum with a brush attachment. Shine a
flashlight through the condenser to check for dirt
between the fins. If dirt remains, a method suitable
to remove the contamination must be used to ensure
air flow.
2. Modular Units Only: Clean the washable filter with a
mild soap and water solution.
26
Warning
Arctic Pure Water Filter System
Engineered specifically for Manitowoc ice machines.
This water filter is an efficient, dependable, and
affordable method of inhibiting scale formation, filtering
sediment, and removing chlorine taste and odor.
Manitowoc Cleaner and Sanitizer
Manitowoc Ice Machine Metal Safe Cleaner is available
in convenient 16 oz. (473 ml) bottles. Manitowoc Ice
Machine Sanitizer is available in 16 oz. (473 ml) and
1 gal (3.78 L) bottles.
Cleaner Part Number
16 oz. 000000084
Removal from Service/Winterization
1. Clean and sanitize the ice machine.
2. Press the power button and turn off the ice machine.
3. Turn off the water supply, disconnect and drain the
incoming ice-making water line at the rear of the ice
machine and drain the water trough.
4. Energize the ice machine, wait one minute for the
water inlet valve to open and blow compressed air in
both the incoming water and the drain openings in
the rear of the ice machine to remove all water.
5. Press the power button and turn off the ice machine.
Disconnect the electric power at the circuit breaker
or the electric service switch.
6. Fill spray bottle with sanitizer/water solution and
spray all interior food zone surfaces. Do not rinse
and allow to air dry.
7. Replace all panels.
WATER-COOLED ICE MACHINES
1. Perform steps 1-6.
2. Disconnect the incoming water and drain line from
the water-cooled condenser.
3. Energize the ice machine in the freeze cycle. The
increasing refrigerant pressure will open the water
regulating valve.
4. Blow compressed air through the condenser until no
water remains.
5. Replace all panels.
Section 4
Sanitizer Part Number
16 oz. 9405653
1 Gallon 94-05813
Part Number 000007644 8/14