Videotec WASPT Serie Manuel D'instructions page 21

6.12 Washer installation (NXPTZ
SERIES2 range)
Installation examples (6.13 Examples of
washer installation, page 20).
Fasten the support (01) onto the body of the PTZ
with the metal clip (02) supplied with the PTZ
camera.
02
Fig. 36
Shorten the semi-rigid washer pipe (01) as needed.
Unscrew the nut (02) from the joint and slide it along
the pipe. Insert the end of the pipe into the ogive
(03).
01
Fig. 37
Lock the nut to the coupling.
Fig. 38
Tighten the delivery joint.
Fig. 39
MNVCWASPT_2222_EN
Unscrew the knurled nut (01) from the delivery joint
(02). Insert the knurled nut on the delivery pipe (03).
Insert the end of the delivery pipe into the spinner
(04). Lock the nut to the coupling.
Fig. 40
Fasten the semi-rigid pipe (01) to the washer support
01
using the plate (02), the screws (03) and the washers
(04) supplied with the PTZ camera.
03
02
Fig. 41
To calibrate the jet, orientate the nozzle towards the
window of the PTZ camera.
Fig. 42
To start the wash system refer to the PTZ camera
manual.
02
01
03
01
04
04
03
02
19