Videotec WASPT Serie Manuel D'instructions page 10

6.2 Choosing the power supply
Depending on the version, the device can be
provided with different power supply voltages. Their
value is shown on the product identification label.
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
When commencing installation make
sure that the specifications for the power
supply for the installation correspond with
those required by the device.
Check that the power supply socket and
cable are adequately dimensioned.
Use a power cable that is suitable for
outdoor use (example: H05RH-F).
6.3 Open the box
Open the cover of the water-proof box and connect
as described below.
Fig. 6
8
6.4 Board description
BOARD DESCRIPTION
Connector Function
J1 Power supply for the board
J7 Wiper
J8 Optional board (DTWRX)
J9 I/O management and pump functions
FUS1 Power supply selection fuse (230Vac)
FUS2 Power supply selection fuse (120Vac)
FUS3 Power supply selection fuse (24Vac)
Tab. 1
J8
J9
Fig. 7
FUS1
FUS2
FUS3
J7 J1
MNVCWASPT_2222_EN