Videotec WASPT Serie Manuel D'instructions page 17

Fasten the pipe to the washer support using the
bracket (01), the screws (02) and the washers (03)
supplied with the PTZ camera.
Block the joint using the clip (04) supplied with the
PTZ camera.
03
02
Fig. 19
To calibrate the jet, orientate the nozzle towards the
window of the housing.
Fig. 20
To start the wash system refer to the PTZ camera
manual.
MNVCWASPT_2222_EN
01
04
6.8 Washer installation (ULISSE2)
Installation examples (6.13 Examples of
washer installation, page 20).
Position the nozzle support bracket (01) in the
appropriate groove (02) on the base and lock it
using the screws and washers (03). Dismantle the
nozzle (04) from the semi-rigid pipe on the washer
supplied. Position the nozzle and lock it using
washer and nut (05). Install the gasket (06) on the
bottom hole on the bracket. Pass the delivery pipe
(07) through the gasket and connect it to the nozzle.
04
05
01
06
Fig. 21
Secure the delivery pipe using the provided cable
tie.
Fig. 22 Final washing position.
To start the wash system refer to the PTZ camera
manual.
07
02
03
15